Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual

Page: 517 / 1218

Parameters (H) Protective function parameter
FR-A800 5 - 315
5.10.4 Earth (ground) fault detection at start
Select whether to enable/disable earth (ground) fault detection at start. When enabled, earth
(ground) fault detection is performed immediately after a start signal input to the inverter.
●
If a ground fault is detected at start while Pr. 249 = "1", the output-side earth (ground) fault
overcurrent (E.GF) is displayed and the outputs are shut off. (Refer to page 6-26.)
●
The Pr. 249 setting is enabled during V/F control and Advanced magnetic flux vector control.
●
When the Pr. 72 "PWM frequency selection" setting is high, enable the ground fault detection at
start.
5.10.5 Varying the activation level of the undervoltage protective function
If the undervoltage protection (E.UVT) activates due to unstable voltage in the power supply, the un-
dervoltage level (DC bus voltage value) can be changed.
Applicable for the 200 V class.
Applicable for the 400 V class.
Pr. Name
Initial
value
Setting range Description
249
H101
Earth (ground) fault
detection at start
0
0 Without the earth (ground) fault detection at start
1 With the earth (ground) fault detection at start
NOTES Because of the detection performed at start, the output is delayed by approximately 20 ms at
every start.
Use Pr. 249 to enable/disable ground fault detection at operation start. Ground faults are detected
always during operation regardless of the Pr. 249 setting.
If a smaller-capacity motor is used with the FR-A820-00340(5.5K) or higher and FR-A840-
00170(5.5K) or higher, ground fault protection may be insufficient.
Pr. Name
Initial
value
Setting range Description
598
H102
Undervoltage level 9999
175 to
215 V DC
Set the DC voltage value at which E.UVT occurs.
350 to
430 V DC
9999 E.UVT occurs at 430 V DC
NOTES Do not use this function when switching to an external battery, since the inrush current when
power is restored increases, as the undervoltage level is decreased.
For the 200 V class inverters, the setting is available for the FR-A820-02330(45K) or lower.
The Pr. 598 setting is invalid during PM sensorless vector control. The Pr. 598 setting is also invalid
during PM sensorless vector control for the first or second functions.
V/F V/F V/F
Magnetic flux Magnetic flux Magnetic flux