PR 5500 Instrument Manual
Commissioning
Sartorius EN-267
t
y
A selection window appears.
t
t
Select and confirm the desired line using the
cursor.
If ‘disabled’ is selected, no weight values or
statuses can be transmitted.
Only for application programmers who want to
use the entire range.
If ‘WP A’ has been selected, e. g. 32 bytes can be
selected under ‘I/As’ nevertheless. However, the
first 8 bytes are used by WP A.
[Fieldbus address]
The input is dependent on the respective fieldbus.
t
t
Press the [Save] soft key to save the settings.
5.19.6.2 ProfiBus-DP Settings for S7
Requirements
-
The PR 1721/61 ProfiBus-DP fieldbus card is installed; see Chapter 4.4.8.
-
The parameters have been selected and saved according to the weighing points (1x WP = 8 byte I/O);
see Chapter 5.19.6.1.
Procedure
t
t
Establish communication with the PLC (in this case: SIEMENS S7-300/400).
t
t
Create/open a project in the SIMATIC MANAGER.
t
t
Under ‚HW config. > Tools > Install GSD files‘, load the file ‚SART_5500.gsd‘ from the CD.
t
y
This file appears under profile -> … as ‚PR 5500 Process Controller‘.
t
t
Select the appropriate modules (I/O size consistent) here according to the device configuration.
t
t
Find the access addresses in the relevant application manual (Chapter ‚Description of the I/O Area‘).
Example: The gross weight should be read for weighing point WP A.
I/O size = 8 bytes, counted from byte 0–7
Card Test
The fieldbus card has 2 LEDs (OP, ST). Communication is functioning correctly when the LEDs are green (see
Chapter 4.4.8.
All inputs and outputs are displayed under [System maintenance] - [Test hardware] - [I/O card test] -
[Option-FB PR 1721/61].
Note
Further details can be found in the supplementary application manual ‚How to...‘ (available
upon request from [email protected]).
Summary of Contents for Sartorius Intec Maxxis 4 PR 5500
Page 406: ......