12. Serial RapidIO Registers > Serial Port Electrical Layer Registers
369
Tsi578 User Manual
June 6, 2016
Integrated Device Technology
www.idt.com
12:15
TX_BOOST[3
:0]
Transmit Boost control. Programmed boost value (ratio of drive level of
transition bit to non-transition bit) is:
boost = -20*log(1-(tx_boost[3:0]+0.5)/32)dB, except that setting
tx_boost to 0 produces 0dB of boost. This produces results up to
5.75dB in steps of ~0.37dB.
R/W
0xC
16
RX_PLL_PW
RON
Power up/reset the receive PLL
0 = Rx PLL off
1 = Rx PLL on
This bit is read only unless SMACx_CFG_GBL[BYPASS_INIT] is set to
1.
R/W
0x1
17
RX_EN
Enable receive clock and data outputs.
RX_EN can only be asserted when both rx_pll_pwron and rx_pll_state
are both asserted.
Set to 1 to enable Receive Data; 0 to disable Receive Data.
This bit is read only unless SMACx_CFG_GBL[BYPASS_INIT] is set to
1.
R/W
0x1
18
DPLL_RESE
T
A rising edge resets the frequency register of the DPLL. The rising
edge can be generated by writing a 0 and then a 1 to the register bit.
R/W
0x1
19:20
Reserved
N/A
R/W
0
21:23
RX_EQ_VAL[
2:0]
Receive Equalization control. Internal linear equalizer boost is
approximately = (rx1)*0.5dB
For example, 100 = 2.5dB boost
R/W
0x5
24:26
RX_DPLL_M
ODE[2:0]
DPLL Mode selection
When RX_EN is not asserted, this can change any time. This should
NOT change when RX_EN is asserted,
R/W
0x0
27
TX_CKO_EN
Set to “1” to power-up clock for Transmit Domain. Set to “0” when port
is not in used. Have to be set to “1” even when only 1 lane is in used.
R/W
1
28:29
LOS_CTL[1:0
]
Enable LOS detector and/of filtering of raw LOS output
00 = LOS detector disabled
11 = Heavy filtering for generic LOS signaling
Other values are reserved.
R/W
0x0
30
RX_ALIGN_E
N
Enable Word Alignment
Has to be turned off during PRBS test (
“Bit Error Rate Testing (BERT)”
R/W
1
31
Reserved
N/A
Note: Only write 1 to this reserved field.
R/W
1
(Continued)
Bits
Name
Description
Type
Reset
Value
