H21/32
Page
3/3
Valve Seat Ring Assembly
Maintenance Procedure
밸브
시트
링
어셈블리
정비점검
절차
Section No.
M21120
Rev.
1B
HYUNDAI HEAVY INDUSTRIES CO., LTD
.
Engine & Machinery Division 06.04/CJC
5.
그림 2와 같이 누르거나 망치질을 하여 시트 링을
끼워넣는다.
6.
밸브 그라인딩 공구를 사용하여 시트 링을 그라인드
작업한다. ( 의
“
시팅 면의 그라인딩
작업
”
부분을 참조하십시오.)
7.
수압 시험을 실시하여 새 밸브 시트 주변의 누수상
태를 점검한다.
시험 압력 : 7 - 10 bar
* 큰 사이즈 밸브 시트 링을 이용한 수정
밸브 시트 링 과 실린더 헤드와의 좸쇄(지름으로)가 아
래의 최소 한계 값을 초과하면 특별한 조치를 해야 한다.
즉, 특별히 크게 밸브 시트 링을 제작하고 실린더 헤드
의 밸브 시트 링 접촉부위를 재가공 하여야 한다.
(상세한 사항은 현대중공업 엔진A/S부에 문의바랍니다.)
* 공칭 좸새 : 0.049~0.093, 지름으로
* 최소 좸쇄값 : 0.030, 지름으로
5. Fit the seat ring by pressing or hammering on
the tool as shown in fig 2.
Fig. 2 Mounting of intake and exhaust valve seat rings
(흡기 및 배기 밸브 시트 링의 조립)
Tool for exhaust valve seat ring (Optional)
Tool for intake valve seat ring (Optional)
91.660
91.650
6.
Grind the seat ring by valve grinding tool.
(See “
Grinding of the seating surface
”
in )
M21200
M21200
7.
Check water leakage around the new valve seat
by hydraulic pressure test.
Test pressure : 7 - 10 bar
* Repair by using oversize valve seat rings
If the interference between a valve seat ring and a
cylinder head exceeds the following minimum limit, a
special action should be taken, i.e. using a specially
oversized seat ring and re-machining cylinder head.
(For detail, please contact Engine After-sales Service
Dep’t of Hyundai Heavy Industries Co., Ltd.)
* Nominal interference : 0.049~0.093, in diameter
* Minimum limit : 0.030, in diameter