H21/32
Page
1/1
Fuel Injection Pipe Block
Maintenance Procedure
연료분사
파이프
블록
(Mono)
정비점검
절차
Section No.
M52300
Rev.
1A
HYUNDAI HEAVY INDUSTRIES CO., LTD
.
Engine & Machinery Division 05.04/KJC
연료 고압 블록의 체결 방법
연료 분사 펌프,연료 분사 밸브의 분해 및 교체등으
로 인해 연료 고압 블록을 분해후 다시 조립할때 볼트,
너트 위치 순서에 따라 3단계 조임력으로 체결한다.
체결 조임력 : 10Nm -> 30Nm -> 60Nm( 3단계)
체결 순서 :
1차 : 조임토크 10Nm로
P1 -> P2-> H2 -> H1
2차 : 조임토크 30Nm로
P2 -> P1 -> H1 -> H2
3차 : 조임토크 60Nm로
P1 -> P2 -> H2 -> H1
Tightening procedure
In case of overhauling or replacement of Fuel
injection pump, Fuel injection valve, dismantling
and assembling Fuel injection pipe block is required.
Then, Tighten torque by 3-step according to the
position orders of the nut.
Tightening torque : 10Nm -> 30Nm -> 60Nm (3 steps)
Tightening orders :
1
st
: by tightening torque 10Nm
P1 -> P2 -> H2 -> H1
2
nd
: by tightening torque 30Nm
P2-> P1 -> H1 -> H2
3
rd
: by tightening torque 60Nm
P1 -> P2 -> H2 -> H1
Fig.1 Bolting no. of Fuel injection pipe block
(연료 고압 블록의 볼트 번호)
P1
P2
H1
H2