All type
Page
3/3
Replacement of Resilient Mount.
Maintenance Procedure
탄성지지대의
교체
(Youil made)
정비점검
절차
Section No.
M11100
Rev.
3A
HYUNDAI HEAVY INDUSTRIES CO., LTD
.
Engine & Machinery Division 05.04/KJH
조 치
검사 결과
조치
모든 간극 검사 양호
검사 완료
간극 상태 불량
탄성지지대 설치 절차에
의거 간극 조정
간극 조정 불가
해당 탄성지지대 교체
(탄성지지대 교체 절차에
따름)
간극 조절 절차
◈ Protection cap을 제거하고 fixing bolt(6), spring
washer(5), top lock ring(4)을 분해한다.
◈ Buffer(2)를 Steel shim에 닿을 때까지 시계 방향
으로 돌린다.
◈ 반대로 Buffer를 반 시계방향으로 완전히 4바퀴
돌려 탄성지지대의 Base casting에 닿도록 한다.
◈ Buffer를 시계 방향으로 2바퀴 돌려 Steel shim
과 Internal buffer의 간극이 4mm가 되게 한다.
◈ 다시 모든 탄성지지대의 간극을 검사한다.
◈ Fixing bolt(6), spring washer(5), top lock ring(4),
protection cap을 분해의 역순으로 조립한다.
Follow-Up Measures
Clearance Adjustment Procedure
◈
Remove Protection cap and loosen fixing bolt(6),
spring washer(5) and top lock ring(4).
◈
Turn a buffer(2) to clockwise direction until it is
contacted with a steel shim.
◈
Turn a buffer full 4 turns to counter clockwise
direction until it is contacted with a base casting.
◈
Make sure a clearance become 4mm by rotating
a buffer 2 turns.
◈
Recheck clearance of all resilient mountings.
◈
Assemble fixing bolt(6), spring washer(5), top
lock ring(4) and a protective cap.
Results of a Inspection
Follow-Up Measures
Everything is O.K.
Continue to next mounting
Clearance condition is
Bad
Adjust a clearance
according to instruction
for installation of
resilient mounting
Impossible to adjust a
Clearance
Replace that resilient
mounting (by instruction
for replacement of resilient
mounting)