All type
Page
5/5
Cooling Water and Its Control
Cooling Water Treatment
냉각수
및
관리
냉각수
처리
Section No.
G07100
Rev.
1G
HYUNDAI HEAVY INDUSTRIES CO., LTD
.
Engine & Machinery Division 09.11/KCM
냉각수의
보충
냉각 시스템을 청소하고 난 직후, pH 값이 약 7일 때
까지 철저하게 시스템을 물로 씻어내고 나서 물을 빼낸
다.
냉각수 팽창 탱크를 증류수로 채운다
.
이때 냉각수 처
리 작업을 위한 여유를 남겨놓고 채운다.
메이커의 지침서에 따라서 방지제 희석용액을 준비하
여 팽창 탱크에 첨가한다.
팽창 탱크의 표준 수위까지 증류수를 추가한다.
부식 방지제의 정착을 위해 메이커의 추천에 따라 엔
진을 가동시키거나, 최소 24시간동안 가동시킨 후, 확인
을 위해서 냉각수 품질을 점검한다.
만일 증발, 누수 또는 정비 시 배수로 인하여 냉각수의
양이 줄어들면, 냉각수를 보충하여 탱크의 수위를 유지해
야 한다.
증발을 보충하기 위한 냉각수는 증류수가 되어야 한다.
반면에 누수나 배수 때문에 손실된 냉각수는 동일하게
처리된 냉각수이어야 한다. 냉각수를 첨가한 후에는, 냉
각수 성분들이 올바른 농도인지 확인해야 한다.
냉각수는 적어도 2년 간격으로 새롭게 정제
된 냉각수로 전면 교체하십시오.
냉각수의 폐기는 관련 법규에 따라 처리해야
합니다.
Filling-Up of Cooling Water
Directly after cleaning process of the cooling
system, flush the system thoroughly with water until
pH value to be about 7, and then drain the water.
Fill up the system with distilled water until the water
level of the expansion tank to have margin for
treatment.
Prepare the solution of inhibitor according to the
instruction from the maker and add the solution into
the expansion tank.
Add distilled water more to the normal level of the
expansion tank.
Run the engine for settlement according to the
inhibitor maker’s recommendation or at least for 24
hours and then check the quality of the water for
confirmation.
If the amount of cooling water is reduced due to
evaporation or leakage or drainage for maintenance,
the water level of the tank should be maintained by
adding water.
Water for compensating evaporation should be
distilled water, while the water for loss due to leakage
or drainage should be same treated water. After
adding the water, checking of the quality of the water
should be carried out to confirm the correct
concentration of the ingredients.
Replace cooling water completely
with newly treated water with interval of at least
every two years.
Waste cooling water should be
treated in compliance with governing laws.