![Hyundai HIMSEN H21/32 Instruction Book Download Page 116](http://html1.mh-extra.com/html/hyundai/himsen-h21-32/himsen-h21-32_instruction-book_2196320116.webp)
All type
Page
6/8
Installation of Resilient Mounting
General Instruction
탄성지지대의
설치
(Youil made)
일반
지침
Section No.
G11100
Rev.
3B
HYUNDAI HEAVY INDUSTRIES CO., LTD
.
Engine & Machinery Division 05.04/KJH
설치 방법 2
일반적으로 탄성 지지대는 Common base frame에 부
착되어 공급된다. 이 경우에는 아래의 2. 부터 시행하고
만약 부착되어 있지 않다면 Base frame의 Bracket에 탄
성 지지대를 부착하고 다음을 시행한다.
탄성지지대의 교체 작업을 위해 사용되는 Supporting
steel shim은 최소한 25mm가 되어야 하며 3개의
Jacking bolt를 위한 Tap Hole과 탄성지지대의 Base
casting의 치수에 의거한 결합용 Hole이 필요하다.
1.
탄성지지대의 Top casting(5)과 Base frame의
Bracket을 4개의 bolt로 고정한다.
2.
Protection cap을 제거하고 fixing bolt(6), spring
washer(5), top lock ring(4)을 분해한다.
3.
Supporting steel shim을 그림 2와 같이 Dowel pin
으로 탄성지지대에 부착한다.
4.
Jacking bolt를 Supporting steel shim의 Tap Hole에
설치한다. (그림 2) 이때 기초와 Supporting steel
shim 사이의 간격은 최소한 10mm가 되어야 한다.
Method Of Installation 2
If the resilient mounting is clung to the common
base frame(It’s normal), perform from the below No.2.
Otherwise perform below after clinging the resilient
mounting to the base frame.
The height of supporting steel shim, used for
replacement of resilient mounting, should be more
than at least 25mm. It is required that the resilient
mounting has tapped hole for the jacking bolt and
mounting hole in accordance with the dimension of
base casting.
1.
Fix the top casting(5) to the bracket of base
frame by using 4 bolts.
2.
Remove Protection cap and loosen fixing bolt(6),
spring washer(5) and top lock ring(4).
3.
Assemble the supporting steel shim to the
resilient mounting by means of the dowel pin.
4.
Install the jacking bolt at tapped hole. At this time,
it is recommended that the distance between the
foundation and resilient mounting be more than
at least 10mm. (Fig. 2)