AIRCRAFT
Placards and Markings
DA 42 NG AMM
Detail Steps/Work Items
Key Items/References
Page 202
15 Mar 2018
11-20-00
Doc # 7.02.15
Rev. 4
(2)
Remove the adhesives layer of the safety
walk adhesive strips from surface:
S
Use fresh acetone or Socomore®
cleaning cloth (P/N: 29003-C86-C10) to
remove the adhesive layer. Do not use
cleaning or polishing agents which
contain silicon.
(3)
Use water to remove dirt from the surface. If
necessary, add a mild cleaning agent.
Refer to Section 12-30.
(4)
Use a commercial solvent to remove grease
from the surface. The surface must be
totally clean from grease or dirt.
(5)
Place the safety walk template on the center
wing.
Refer to Figure 3.
(6)
Make sure that the template orientation is
parallel to flight direction.
(7)
Remove the protective layer from the safety
walk adhesive strips.
(8)
Place the safety walk adhesive strips into
the slots of the safety walk template.
(9)
Use a roller to flatten and paste on the
safety walk adhesive strips.
(10)
Place the ‘No Step’ placard (front) and the
‘Foot Step’ placard (rear) according to the
safety walk template.
Refer to Figure 3.
(11)
Use a clean cloth to flatten the ‘No Step’
placard and the ‘Foot Step’ placard.
(12)
Remove the safety walk template.
Summary of Contents for DA 42 NG
