AIRCRAFT
DA 42 NG AMM
Stabilizers
Doc # 7.02.15
Rev. 4
55-20-00
Page 201
15 Mar 2018
Maintenance Practices
1. General
These Maintenance Practices tell you how to remove and install the elevator and trim tab. Refer to
Sections 27-30 and 27-31 for data on the elevator and trim tab control setting.
2. Remove/Install the Elevator
A. Remove the Elevator
Detail Steps/Work Items
Key Items/References
(1)
Remove the horizontal stabilizer fairing.
S
Remove the 4 screws that attach the fairing
to the structure.
Refer to Figure 2.
(2)
Remove the horizontal stabilizer tips:
S
Remove the 8 screws that attach the tip to
the stabilizer.
Hold the tips.
(3)
Release the 2 fork-end fittings from the trim-tab
cranked actuating levers.
Under the elevator.
(4)
Remove 2 bolts, nuts and washers which attach
the elevator horn rib to the elevator.
Refer to Figure 2.
(5)
Remove the pivot pins from the end bearings:
S
Remove the roll pin.
S
Pull the pivot pin out of the end bearing.
Hold the elevator.
(6)
Pull the elevator aft to release the elevator horn
and hinge assemblies.
(7)
Put the elevator in a stand or on a padded
surface.
Summary of Contents for DA 42 NG
