AIRCRAFT
Navigation
DA 42 NG AMM
Page 206
15 Mar 2018
34-10-00
Doc # 7.02.15
Rev. 4
4. Remove/Install an Altimeter Orifice
A. Remove an Altimeter Orifice
Detail Steps/Work Items
Key Items/References
(1)
Make sure that the ELECT. MASTER switch is
set to OFF.
Instrument panel, left side.
(2)
Remove the instrument panel cover.
Refer to Section 25-10.
(3)
Remove the static hose (blue) from the rear of
the altimeter.
(4)
Disconnect this part of static hose (blue) from
the next T-fitting.
Hold the T-fitting.
(5)
Carefully warm up the section around the
orifice.
Use a heat gun.
(6)
Use an edgeless object to press out the orifice.
Use a screwdriver.
B. Install an Altimeter Orifice
Detail Steps/Work Items
Key Items/References
(1)
Carefully warm up 50 mm (2 in) from one end of
the hose.
Use a heat-gun.
(2)
Press the orifice in the static hose.
Use a screwdriver to press in the orifice.
(3)
Connect the hose to the static T-fitting.
Hold the T-fitting.
(4)
Connect the other end of the hose to the
altimeter.
Summary of Contents for DA 42 NG
