AIRCRAFT
Fuel
DA 42 NG AMM
Page 204
15 Mar 2018
28-40-00
Doc # 7.02.15
Rev. 4
B. Install a Fuel Temperature Sensor
Detail Steps/Work Items
Key Items/References
(1)
Install a new seal onto the temperature sensor.
(2)
Screw the temperature sensor into the mounting
boss on the fuel tank.
Remove the blanking cap. Make sure
that the seal is seated correctly.
(3)
Install the access panel in the wing root rib:
S
Move the access panel into position over the
studs in the wing root rib.
S
Install the 11 washers and nuts that attach
the access panel to the wing root rib.
(4)
Install the wing onto the airplane.
Refer to Section 57-10.
(5)
Refuel/transfer fuel into the fuel tank assembly
for which you installed the temperature sensor.
(6)
Bleed the fuel system.
Refer to Section 28-20.
(7)
Do a test for fuel leaks at the temperature
sensor that you replaced.
(8)
Do a test for the correct operation of the related
fuel temperature sensor:
S
Set the ELECT. MASTER switch to ON.
S
Set the ELECT. MASTER switch to OFF.
Monitor the multi function display screen
of the ICS. The fuel temperature
indications must both indicate the
ambient temperature.
Summary of Contents for DA 42 NG
