AIRCRAFT
Stabilizers
DA 42 NG AMM
Detail Steps/Work Items
Key Items/References
Page 202
15 Mar 2018
55-40-00
Doc # 7.02.15
Rev. 4
(2)
Install the rudder assembly:
S
Move the rudder to engage the top pivot pin
in the upper pivot bearing.
S
Install the 2 washers and nuts that attach
the rudder to the rudder mounting bracket.
Torque: 6.4 Nm (4.7 lbf.ft.). Use new
self-locking nuts.
(3)
Connect the trim-tab control rods:
S
Align the control rod eye-ends with the trim
control levers.
S
Install the 2 bolts, washers and nuts that
attach the eye-ends to the control levers.
(4)
If MÄM 42-600 is installed and the rudder
sealing tape and the sliding tape are worn:
S
Remove the rudder sealing tape and the
sliding tape from the fin and the rudder
surface.
S
Use solvent to clean the surfaces.
S
Install the self adhesive sliding tape to the
rudder surface.
S
Install the self adhesive sealing tape to the
rudder fin surface. The not adhesive half of
the sealing tape must protrude from the fin
towards the rudder and cover the gap.
(5)
Do a test for the correct range of movement of
the rudder control.
Refer to Section 27-20.
(6)
Do a test for the correct range of movement of
the rudder trim control.
Refer to Section 27-21.
(7)
If necessary for your Airworthiness Authority do
a duplicate inspection of the rudder control
system.
Summary of Contents for DA 42 NG
