i-on Range
Installer Menu Options
Page 81
You can change the wiring type of each wired expander individually, see page
50
Note: Make sure that all zones are wired correctly for the selected wiring type.
See the relevant
Installation Guide
for wiring details.
User Access
To give users access to various system facilities select
System Options – User
Access
. Press the
or
keys to scroll up or down the list on the display. To
allow access press
repeatedly until ―Yes‖ appears next to the selected
option. To deny access press
until ―No‖ appears next to the selected option.
Press
when you have finished.
HUA Keys Active
This option allows users to start an alarm from the keypads by pressing both
the Hold Up Alarm keys at the same time. This option applies to all keypads,
both radio and wired, and is not affected by allocating keypads to specific
partitions.
Yes
The HUA keys on all keypads are functional.
No
The HUA keys are disabled.
Note: If HUA Confirmation has been enabled in
System Options – Confirmation –
BS8243
then two separate HUA events are needed within the confirmation
time in order to start a HUA. See page 87 for HUA Confirmation Time.
Quick Set
Note: If you enable the quick set keys the control unit no longer complies with
EN50131.
This option controls the operation of the A, B, C or D keys.
Yes
It is possible to set the alarm system by pressing A, B, C
or D without entering an access code.
No
The user must enter an access code (or present a tag)
before pressing the A, B, C or D keys.
Quick Omit
This option allows users to omit a zone that is active (has it‘s alarm contacts
open) while they are setting the system. The zone must have the Omittable
attribute (see page 46).
Yes
By pressing
the user can set the system if there are
zones with the Omit Allowed attribute active.
No
The user must go to the Omit Menu to set the system if a
zone is active.
User Code Required
Use this option to ensure that an installer or maintainer cannot gain access to
program the system unless a user is present:
Yes
After the installer/maintainer enters their access code, the
system asks for a user access code before allowing access
to the Installer Menu.
Summary of Contents for i-On 40
Page 1: ......
Page 10: ...i on Range Page x This page is intentionally blank...
