i-on Range
Installer Menu Options
Page 123
―O/C‖ means Open Circuit.
―0k00‖ means zero resistance or closed circuit.
Signal Strengths
This option allows you check the received signal strength from all the radio
transmitters belonging to the system.
The keypad display shows first: the strength of the most recent signal it has
received from a transmitter, and second: (in brackets) the minimum strength
signal it has received from the transmitter since the records were last reset.
The control unit is always recording signal strengths, whether or not you are
using the Signal Strength menu.
Note: If you have fitted a WAM to act as a repeater for weak detector signals
then you will not see any change in the signal strength reported for those
detectors. However, you should note the signal strength of the WAM,
since that device is now passing on the information from the detectors
whose signal you are trying to amplify.
To reset the signal strength records press ―D‖ while you are in the
Tests – Signal
Strength
menu. When you press ―D‖ then the control unit resets the signal
strength records for ALL transmitters.
You can also reset the signal strength record of individual transmitters. To do
this press ―#‖ while the display shows the signal strength of the transmitter
you wish to reset.
There are four sections to the Signal Strength menu:
Detector Signals
,
Radio
Sirens
,
Radio Keypads
, and
WAMs
. Press
or
followed by
to select the
section you want to test.
Detectors
The display shows the strength of the most recently received signal from each
learned radio zone. The bottom line of the display shows the zone name. To
see the zone number press
or
.
Radio Keypads
The display shows a list of the received signal strengths from each radio
keypad.
External Sirens
The display shows a list of the received signal strengths from each 760ES
siren.
WAM Signals
30 40 50 160
The display shows a list of the received signal strengths from each learned
WAM.
Outputs
This option has three sections:
Radio Outputs
,
Wired Outputs
and
Plug-by Outputs
.
Note that the i-on16 does not have plug-by outputs, and will not show
that option.
Press
or
followed by
to select the section you want to test.
Summary of Contents for i-On 40
Page 1: ......
Page 10: ...i on Range Page x This page is intentionally blank...
