Cooper Security i-On 40, Engineering Manual

Page: 211 / 228

i-on Range Appendix III
Page 201
The Red Trouble LED glows. The WAM starts
transmitting its identity.
At the Keypad
When the control unit learns the WAM‘s identity
the keypad gives a double beep.


1. Press

The display shows the default name for the
newly learned WAM.


3. Leave the installer menu to save changes.
Teach the WAM the Identity of the Detectors
1. Enter programming mode as follows:
a) Open the tamper switch.
The Red Trouble LED glows.
b). Press SELECT.
The blue LED 1 glows. The WAM is in menu 1.
2. Press SET.
If any blue LEDs flash then those channels are
already in use.
3. Activate tampers on all transmitters that the
WAM needs to learn.
Each time the WAM learns a detector a blue LED
glows to show the channel that detector is using.
4. Leave programming mode as follows:
a) Leave menu 1 by pressing ESC.
The blue LED 1 glows steadily.
b) Press ESC again.
The blue LED 1 goes dark. The sounder gives a
regular beeping tone to remind you to replace
the lid.
c) Close the lid tamper.
After a few seconds the WAM bleeps twice and