Cooper Security i-On 40, Engineering Manual

Page: 116 / 228

Installer Menu Options i-on Range
Page 106
Disabled
The channel stays active until an Installer or user resets the system.
Enabled
The system rearms Channel 3 once the siren timer has expired. Once the
Channel is rearmed, the system is ready to report any new alarm. The
system bypasses any detectors that are still triggered.
Notes:
If a Final Exit Zone is triggered, Channel 3 becomes active at the end of
the Programmed Entry time.
21CN FF Ack Time
(This menu appears only if you select ―Fast Format‖ in
Communications - Report
Type
. The menu does NOT appear if a GPRS or Etherner module is fitted.)
A PSTN line connected to a BT21CN line (or equivalent) will take longer to
acknowledge a Fast Format transmission. This option allows you to adjust the
length of time that the control unit waits for the ARC acknowledgement. You
can adjust the acknowledgement time from a minimum of 400ms up to a
maximum of 1200ms in 100ms steps.
Send Tamper as Burg
When using CID or SIA reporting this option allows you to program the control
unit to send tampers as alarm.
If you select Disabled, (the default) then the control unit sends all CID/SIA
messages as specified in
Communications – ARC Reporting – CID/SIA Events
.
If you select Enabled then for full alarm response the control unit sends
tampers as burglary (BA) and sends Contact ID 130 in place of Contact ID 137.
Dynamic Test Call
Note: If this option is not visible then static test calls are enabled. To use
dynamic test calls disable static test calls first.
In dynamic testing the system makes a test call 24 hours after the last alarm
communication. To enable dynamic testing select
Communications – ARC
Reporting – Dynamic Test Call – Enabled
.
Static Test Call
Note: If this option is not visible then dynamic test calls are enabled. To use
static test calls disable dynamic test calls first.
In static testing the system makes a test call either on:
Every day at one particular time of day or
On the same day of every week, or
On one day every month.
To make test calls at a set time every day select
Communications – ARC
Reporting – Static Test Call – Daily.
From the display select a number between 01
and 24 to choose the time of day for the call. For example, select 18 to
program the control unit to make a static test call at 6:00pm every day.
To make test calls on the same day every week select
Communications – ARC
Reporting – Static Test Call – Weekly.
From the display select the day of the week