Cooper Security i-On 40, Engineering Manual

Page: 174 / 228

Step by Step Programming Procedures i-on Range
Page 164
3. Press

.


4. Press

.


5. Press

.
30 50 160 On an i-onEX range control
unit the bottom line of the display shows the
first of the available radio expanders, for
example:
Go to step 6.


16 40 On an i-on16 or i-on40 control
unit the bottom line of the display shows:
Go to step 8.


30 50 160
6. Press

or

to select the expander that you
wish allocate the radio output to.
Note: This example assumes that your radio
expanders are bus devices 02 and 05. The
numbers may be different on the system you
are working on.


30 50 160
7. Press

.
The top line of the display shows the first in a
list of unused radio outputs, for example:


8. Press

or

until the display shows the
output you wish to add, for example:
Note that if the bottom line of the display
shows an output name this indicates that the
output has been previously taught to a
receiver.


9. Press

.


10. Make sure that the receiver is in learn mode
(see Appendix IV).
11. Press

.
The control unit transmits its identity to the
receiver. When the receiver has successfully

