Cooper Security i-On 40, Engineering Manual

Page: 22 / 228

Basic Programming Procedures i-on Range
Page 12
Set Only user code). To disable this feature see
System Options – User
Access – User Code Required
on page 81.
2. If you key in the code incorrectly, the display shows the time and date
again, and gives an error tone. Key in the code again. If you key in a total
of ten consecutive incorrect codes then the system locks you out for 90
seconds.
Transferring to Another Keypad
While in the Installer Menu, you can transfer to any other keypad without
leaving the Installer Menu. To do this simply go to any other keypad and enter
the Installer access code. The new keypad will pick up your position in the
Installer Menu. The keypad you have left will briefly display the message
―Installer session transferred‖ for 5 seconds before reverting to the time and
date.
To leave the Installer Menu at any time:
1. Press

until the display shows:


2. Replace the control unit lid (if you removed it
earlier). Ensure the control unit tamper switch
is closed.
3. Press

to leave Installer menu.
(Press

if you do not want to leave the menu.)
On an i-on16 or i-on40, the control unit saves
your changes and the display shows the time
and date. The system is ready for use.


On an i-onEX range control unit the display
shows:
The control unit scans the bus to check for any
devices that have been added or removed
without using the installer menu. On a large
system this may take several seconds.


When the control unit has finished scanning the
bus, the display shows the time and date. The
system is ready for use.


Duplicated Bus Devices
If the control unit finds that two bus devices
have the same bus address when you try to
leave Installer Menu, then it will show the
duplicated addresses on the keypad screen.
You must press

to re-enter the Installer
Menu, and then go and re-address one of the
duplicated devices.