Cooper Security i-On 40, Engineering Manual

Page: 157 / 228

i-on Range Step by Step Programming Procedures
Page 147
On an i-on16 or i-on40 control unit the bottom
line of the display shows:
Go to step 6.


30 50 160
5. Press

until the display shows:


6. Press

.
The bottom line of the display shows the first in
a list of the available wired keypads.


5. Press

or

to select the keypad that you wish
to name. Then press

.
The bottom line of the display shows:


6. Press

.
The bottom line of the display shows the
keypad‘s current name. The cursor is on the first
character on the left.


7. See page 18 for hints on how to edit names.


8. Press

to save the completed name.


9. Carry on with any other programming that you
need to do. DON‘T FORGET to leave the Installer
Menu in order to save the changes you have
made (see page 12 ).
Assigning a Wired keypad to Partitions
Note: If you selected “Part set mode” during Initial Power-up then you cannot
assign a keypad to a partition (see
System Options–Restore Defaults–Factory
Defaults
on page 90 if you want to change the system from Part Setting to
Partitions).
1. Enter Installer Menu.


2. Press

.


3. Press

until the display shows:


4. Press

.