Cooper Security i-On 40, Engineering Manual

Page: 81 / 228

i-on Range Installer Menu Options
Page 71
Notes:
1. Appears only if Exit Mode is “Final Door”, “Lock Set” or “Exit
Terminate”.
2. Appears only if Exit Mode is “Timed Exit” or “Silent Set”.
3. Not available on i-on16, i-on40 or i-on30EX.
4. i-on160EX can have up to 20 partitions, i-on50EX up to five, i-on30EX
and i-on40 up to 4.
Notes for Part Set Options
In a Part Setting System, for Part Set B to work you must have at least
one zone with the attribute Part Set B = “Yes”, see page 46
In the same way, for Part Set C to work you must have at least one zone
with the attribute Part Set C = “Yes”. For Part Set D to work you must
have at least one zone with the attribute Part Set D = “Yes”.
In a Partitioned System, for part set to work within a partition you must
assign the “Part Set” attribute to at least one zone belonging to the
partition.
Options
Note: The default settings for these options are compliant with EN50131, see
page 29. Changes to some of the defaults may render the system non-
compliant.
Name
Use this option to give the Full Set, Part Set, or Partition a name. The
control unit displays this name to the user during setting.
Exit Mode
The exit modes available are:
Timed Set Use this option to make the system set after a
delay. Use the Exit Time menu (see page 74)
to choose the delay.
Note: This option does not comply with
BS8243:2010.
Final Door
Set Use this option to complete setting the system
by closing a door fitted with a Final Exit zone
detector. Note that the exit time is infinite in
this option.
Note 1: If you wish to use Final Door Set exit
mode when part setting then:
a) Make sure that you include a zone with
the Final Exit type as one of the part set
zones.
b) Make sure you select “Final Door” in
Part Set Final Exit As (see page 75).
Note 2: If you wish to use Final Door Set exit
mode for a Partition then make sure you
include a zone with the type Final Exit in
the Partition.