Installer Menu Options
i-on Range
Page 128
Note: The word ―Web‖ will appear in the log entry if the installer logged on
using the web browser.
Downloader and the Log
When i-on Downloader connects to a control unit, the control unit logs the
event as ―Rem Download‖. This indicates that i-on Downloader successfully
connected and disconnected.
The control unit logs a separate event ―Unn Config Change‖ if i-on Downloader
changes the configuration of the control unit. The user number recorded will be
that for the Downloader (see table above).
Logging Tamper Events
Tamper events are normally logged. However please note that the type of
events that are considered to be tampers depends to some extent on the
options the Installer chooses in
System Options – Jamming
and
System Options –
Supervision
(see page 93). When these options are set to ―Tamper‖ then
jamming or supervision failure events will be recorded as tampers.
About
The
About
option in the Installer Menu offers information on the version and
status of the control unit.
If the control unit has a communications module fitted then the About option
also provides information about the module, including IP addresses and port
numbers for modules connected to the Internet.
Panel
This option shows the control unit model, its software revision and whether the
control unit is programmed as partition or part setting. (Press
or
to see
each item of information.)
Expanders
30 50 160
This option shows the first item in list of all the expanders known to the control
unit. If you select an expander by scrolling up or down the list and then press
, the display shows the revision of software running on the expander.
Keypads
This option shows the first item in a list of the keypads known to the control
unit. If you select a keypad by scrolling up or down the list and then press tick,
the display shows the revision of software running on the keypad.
PSU
30 50 160
This option shows the first item in a list of the EXP-PSUs known to the control
unit. If you have more than one EXP-PSU, select one by scrolling up or down
and then press tick. The keypad display will then show the revision of software
running on the EXP-PSU.
Summary of Contents for i-On 40
Page 1: ......
Page 10: ...i on Range Page x This page is intentionally blank...
