Cooper Security i-On 40, Engineering Manual

Page: 142 / 228

Step by Step Programming Procedures i-on Range
Page 132
9. For Expanders:
Go to the expander. Remove the expander lid.
Hold down the Request/Delete Address button
for at least three seconds.
After three seconds the expander gives a
confirmation tone (two beeps) and its display
shows the address allocated by the control
unit, for example:
Note: DO NOT attempt to address two devices at
the same time. If two or more installers are
working on the same system at the same
time, make sure that only one person is
addressing bus devices at a time.
1-
followed by
03
If you do not wish to accept this bus device
number, hold down the Request/Delete
Address button for at least three seconds
again. The control unit will allocate the next
free number, for example:
1-
followed by
06
NOTE: If there are no more free bus addresses
then the keypad display will display an error
message. This may happen especially if you
are trying to add an EXP-R30, and there are
not three consecutive bus addresses available.

For Keypads:
Go to the keypad. Hold down keys A and

for
at least three seconds.
After three seconds the keypad gives a
confirmation tone and its display shows the
address allocated by the control unit, for
example:
Note: DO NOT attempt to address two keypads at
the same time.


If you do not wish to accept this bus device
number, hold down A and

again and the
control unit will allocate the next free number,
for example:


At this point you can go to any other expander
or keypad device that you wish to add to the
bus and repeat step 9.
10. At the keypad you are using to program the
system press

when you have finished adding
bus devices.

