Cooper Security i-On 40, Engineering Manual

Page: 180 / 228

Step by Step Programming Procedures i-on Range
Page 170
11. Press

or

to scroll through the type list.
You can select any of the types listed on page
61 onwards.


12. Press

to confirm the change in type.


13. Carry on with any other programming that
you need to do. DON‘T FORGET to leave the
Installer Menu in order to save the changes
you have made (see page 12 ).
30 40 50 160
Note: Partitioned Systems
If you are programming a partitioned system then at this point, for some
output types, the top line of the display shows “Partition?”. The bottom
line of the display shows “Partition 1 Yes”. This means that the system is
asking if you want to allocate the output to Partition 1.
You can remove the output from Partition 1 by pressing

or

to change
the “Yes” to a “No”.
Press

or

to scroll to other Partitions. Press

or

to assign the
output to each Partition as required.
Press

when you have finished assigning outputs to Partitions.
Naming a Wired Output
1. Enter Installer Menu.


2. Press

until the display shows:


3. Press

.


4. Press

.


5. Press

.
30 50 160 On an i-onEX range control
unit the display shows the first group of wired
outputs available for editing: those on the
panel.
Go to step 6.

