Cooper Security i-On 40, Engineering Manual

Page: 90 / 228

Installer Menu Options i-on Range
Page 80
Manually setting and unsetting partitions controlled by Calendar Sets will not
alter the times programmed in Calendar events.
Restrictions on Calendar Sets
Please remember the following points when setting up events:
1. You cannot program an event to change the system/partition directly from
one part set level to another. You must program an event to unset the
system/partition first, and another event to set the system/partition to a
different part set level. For example, if event A part sets the system (or a
partition) then you cannot program event B to full set the system. You must
program event B to unset the system and then use event C to full set the
system.
2. If you are unsetting a partition and setting the same partition again then
you must program the setting event to occur at least 10 minutes after the
unsetting event.
System Options
This section of the Installer Menu contains a series of options that affect the
working of the alarm system as a whole.
Note: The default settings for these options are compliant with EN50131, see
page 29. Changes to some of the defaults may render the system non-
compliant.
Wired Zone Type
30 40 50 160
Normally the control unit asks you to select the zone wiring type when you
power up a new installation for the first time, or when you restore the control
unit to factory defaults (see page 14). This sub-menu lets you change the zone
wiring type for either the control unit or for the whole system. There are two
options:
Panel
Zones
This option lets you change the zone wiring type for the control
unit.
All Zones This option lets you change the zone wiring type for the whole
system.
For both options the choices available are: 4-wire CC, 4k7/2k2. 1k0/1k0,
2k2/2k2, or 4k7/4k7.
If you select ―4 Wire CC‖ then the control unit and/or expanders provide five
wired zones, numbered 1 to 5.
There are several options of resistor values for FSL: the keypad display shows
the alarm contact resistor/end of line resistor values for each option.
If you select any of the Panel - FSL options then the control unit provides 10
wired zones, numbered 0 to 9.
If you select any of the System – FSL options then all wired expanders provide
10 wired zones, number 0 to 9.