Cooper Security i-On 40, Engineering Manual

Page: 15 / 228

i-on Range Introduction
Page 5
Expanders
30 50 160
Wired Expander The EXP-W10 wired expander provides connections for:
Either 10 FSL zones or five CCL zones.
One loudspeaker
Four wired programmable outputs
Radio Expander The EXP-R10 radio expander provides 10 channels for radio
detectors. The EXP-R30 provides 30 channels for radio
detectors on an i-on160EX or i-on50EX. When fitted to an i-
on30EX the EXP-R30 provides 20 channels. In addition each
radio expander provides channels for: two radio keypads,
two external radio sounders and two Wireless Accessory
Modules (WAMs) (Note that the i-on30EX supports only one
WAM.). Each radio expander also provides wired connections
for a Loudspeaker. The maximum number of expanders,
detectors, keypads and WAMs depends on control unit type,
see page 8.
Note: The total number of radio detectors that can be
handled by an i-onEX control unit depends partly on
the density of radio transmitters within a given volume.
If there are more than 30 transmitters within 10
meters radius of an expander then some mutual
jamming may occur. Please read “Guidance Notes For
Radio Alarm System” available from
www.coopersecurity.co.uk.
Remote Power
Supply The EXP-PSU remote power supply provides extra power and
more space for standby batteries for larger alarm systems.
The EXP-PSU also provides connections for either 10 FSL
zones or five CCL zones, a loudspeaker and four wired
programmable outputs.
The EXP-PSU connects to the system bus, and
communicates with the control unit in the same way as a
wired expander.
Communications
Each of the i-on range of control units provide sockets for a single plug-on
communication module. The available modules are:
i-dig02
A PSTN module that allows the control unit to report alarm information
using standard protocols such as Fast Format and Contact ID. This
module also allows remote maintenance over the PSTN and sending SMS
messages.
i-sd02 A speech dialler and public switched telephone network (PSTN)
module that allows the control unit to send recorded speech
messages and also report alarm information using standard protocols
such as Fast Format and Contact ID. This module also allows remote
maintenance over the PSTN and sending SMS messages.