Cooper Security i-On 40, Engineering Manual

Page: 156 / 228

Step by Step Programming Procedures i-on Range
Page 146
allow any attributes. See page 46 for a list of
attributes.
When allocating zones to partitions you can
select more than one Partition for each zone.
Press

or

until the end of the bottom line
shows ―Yes‖ to allocate a zone to a Partition. See
page 68 for more information about partitions.
If you want to allocate a zone to all partitions at
once:
Press

or

until the bottom line shows ―All
Partitions‖.
Press

or

until the end of the bottom line
shows ―Yes‖ to allocate the zone to all partitions
or ―No‖ to remove the zone from all partitions
except partition 1.




Note: If you selected “Part set mode” during Initial
Power-up then the display will not show the Partitions
option (see
System Options–Restore Defaults–Factory
Defaults
on page 90 if you want to change the system
from Part Setting to Partitions).
9. Press

to confirm your changes.
The bottom line of the display shows the zone
you were editing, for example:


10. Carry on with any other programming that you
need to do. DON‘T FORGET to leave the Installer
Menu in order to save the changes you have
made (see page 12 ).
Keypads
Naming a Wired Keypad
To name a wired keypad:
1. Enter Installer Menu.


2. Press

.


3. Press

until the display shows:


4. Press

.
On an i-onEX range control unit the bottom line
of the display shows:
Go to step 5.

