Installer Menu Options
i-on Range
Page 84
system by using the option “User Menu – Sys Config – Remotes – PA
Function”.
There are two options available to control sounders and siren:
Sounder on
Unconfirm
When the system is set the control unit activates the internal
sounders when an unconfirmed alarm occurs.
Confirm
When the system is set the control unit does not activate the
internal sounders until a confirmed alarm occurs.
Note: The control unit will not allow you to select “Sounder on - Confirm” at
the same time as “Siren on - Unconfirm”.
Siren on
Unconfirm The control unit operates the siren for all alarms (and overrides
any Siren Delay).
Confirm
When the system is set the control unit does not activate the
siren(s) until a confirmed alarm occurs.
Note: The control unit will not allow you to select “Siren on - Unconfirm” at the
same time as “Sounder on - Confirm”.
Confirmation (UK Variants)
Confirmation Mode
If you are installing a UK version of the control unit then the Confirmation
Mode option allows installers to program a control unit for operation under
either DD243 or BS8243. There are three options:
Basic
If you select this option then the control unit will activate any
output programmed as ―Confirmed Alarm‖ if a second zone is
activated while the system is in alarm. The second zone must
belong to the partition that is in alarm. The installer can also
select whether to allow users to reset the system after a zone
alarm, see page 82.
In addition, the Master User can enable or disable HUD functions
for the whole system by using the option ―User Menu – Sys Config
– Remotes – PA Function‖.
DD243
If you select this option then the control unit reveals sub menus
required to program the system to conform to DD243: Siren On,
Sounder On, Confirmation Time, After Entry, Entry Keypad Lock,
Unconfirmed Reset, Confirmed Reset. The rest of this section
describes each of these sub-menus.
Note: When using Confirmation, and the system is programmed
for Installer Reset after an alarm, the user cannot set the
system after an alarm until the installer has carried out a
reset.
BS8243
Selecting this option reveals all of the same sub-menus as the
DD243 option, but also reveals a sub-menu for programming
confirmed HUA.
Summary of Contents for i-On 40
Page 1: ......
Page 10: ...i on Range Page x This page is intentionally blank...
