Cooper Security i-On 40, Engineering Manual

Page: 145 / 228

i-on Range Step by Step Programming Procedures
Page 135
3. Press

until the display shows:
EITHER (for a wired expander):
OR (for a radio expander):




(The rest of these instructions assume you are
disabling a wired expander. The instructions are
similar but the displays are slightly different for
a radio expander.)
4. Press

.
The display shows:


5. Press

until the display shows:


6. Press

.
The display shows the first in a list of the
expanders that are currently connected to the bus.


7. Press

or

until the display shows the
expander you wish to enable or disable (in this
example, expander W1-04):
The right hand end of the bottom line shows the
state of the expander: ―Yes‖ for enable, ―No‖ for
disable.


8. Press

or

until the end of the bottom line
shows the state you want.
This example shows the expander being
disabled:
Note: If you change your mind and do NOT wish to
disable the device shown then press

or

until the bottom line shows “Yes”.


9. Press

.
The display shows the Enable Expander option.
The control unit disables the expander you
selected in step 7. If you change your mind after
pressing

and wish to enable the expander
then follow steps 6 to 8 again, but ensure that
the bottom line of the display shows ―Yes‖ for
the selected expander.

