i-on Range
Installer Menu Options
Page 119
Test
The control unit provides three options within the Installer Menu to help in
testing: the Test option itself, the View Log option to see what events have
been recorded, and the About option so that you can check on the release level
of the software.
If you think that part of the system is not working correctly then you can use
the Test option to test various peripherals.
The Test option also lets you check the identity of Remote controls, Hold Up
Alarms and Tags.
You can test each part listed in the Test menu as follows:
Sirens and Sounders
This option allows you to test all the warning devices connected to the control
unit. The option is divided into sub-menus allowing you to test specific types of
sounder, as shown in the table below:
Ext. Radio Sirens
This option presents a list of the learned-in radio
sirens. Select a siren for testing by pressing
u
or
n
.
Note that both siren and strobe should operate.
Wired Sirens
This option allows you to operate all outputs
programmed as ―Siren‖ and ―Strobe‖.
Either: Select ―All Sirens‖ to operate all sirens at once.
OR: Press
or
to select the sirens for an individual
partition.
Loudspeakers
With this option you can test any loudspeakers
connected to the system. Either: Select ―All
Loudspeakers‖ to operate all loudspeakers at once.
OR: Press
or
to select the loudspeakers for an
individual partition.
Wired Keypads
Use this option to test the sounders on the wired
keypads. Either: Select ―All keypad sounders‖ to
operate all wired keypad sounders on the system at
once.
OR: Press
or
to select the wired keypads
sounders for an individual partition.
Note that options for radio sirens will not appear if the control unit has not
learned any radio sirens.
Select the type of sounder you wish to test and press
. The sub-menu gives
you the option to test all sounders in a category at once, or to select individual
partitions and test the sounder(s) for that partition. (The display will only
present those partitions that have zones allocated to them.)
Press
to turn the sounder on. Press
to turn the sounder off again. The
display shows the word "On" when the sounder should be operating and ―Off‖
when the sounder should be silent.
Summary of Contents for i-On 40
Page 1: ......
Page 10: ...i on Range Page x This page is intentionally blank...
