BinTec X4000, User Manual

Page: 369 / 498

X4000 User’s Guide 369
Administration of Configuration Files
11
➤
Leave C
ONFIGURATION
M
ANAGEMENT
with EXIT.
Example You have created the configuration file brick.cf, e.g. with the help of the
Configuration Wizard. You have not transferred the file to X4000 over the serial
interface; brick.cf can be found in the directory C:\BRICK on your PC. Your PC
has the IP address 192.168.1.1. If you want to transfer brick.cf from your PC to
X4000 , proceed as follows:
➤
For a Windows PC: Click the Windows Start button then Program
➧
BRICKware
➧
DIME Tools to start DIME Tools. The TFTP server must
be active.
➤
Activate a TFTP server under Unix: see the Software Reference .
➤
Go to C
ONFIGURATION
M
ANAGEMENT
.
If
error is displayed under State of last operation, check your settings:
■
Have you entered an incorrect IP address under TFTP Server IP Address?
■
Does the name of the configuration file consist of more than 8 characters
and the extension of more than 3 (when using DIME Tools)?
■
Does the host not support TFTP (did you forget to start the TFTP server of
DIME Tools before starting the operation)?
■
Is the source file not in the configured directory of the TFTP path of DIME
Tools (when Operation =
get)? To change the TFTP path, refer to
BRICKware for Windows .
■
If none of these points applies, proceed as follows to find the cause of the
problem:
➤
Leave the Setup Tool.
➤
Type in the following in the SNMP shell:
debug config &
.
➤
Reopen the Setup Tool with
setup
.
➤
Carry out the desired operation in C
ONFIGURATION
M
ANAGEMENT
.
If an error occurs, an error message with the cause of the error appears in
the help line of the Setup Tool.
➤
Solve the problem and carry out the operation again.