BinTec X4000, User Manual

Page: 279 / 498

X4000 User’s Guide 279
WAN Interface Card for ISDN BRI
9
To do Proceed as follows to configure the ISDN BRI interface(s) of the expansion
card:
➤
Go to X4E-3BRI, ISDN S0
➧
U
NIT
0 for the first interface.
This menu offers the same options as CM-1BRI, ISDN S0 for the ISDN BRI
interface of the basic unit. For a detailed description, see chapter 7.2.1,
page 137 .
➤
Select ISDN Switch Type: autodetect on bootup.
This setting enables X4000 to use its automatic D-channel detection. As
long as the D-channel detection is running, running appears next to Result
of Autoconfiguration. Once the setting has been found, it is displayed,
e.g.
Euro ISDN, point-to-multipoint.
➤
Select D-Channel, if applicable.
➤
Select B-Channel 1: e.g. dialup.
➤
Select B-Channel 2: e.g. dialup.
Incoming Call
Answering
If dialup connections are to be set up over the ISDN BRI interface, first tell
X4000 how it is to respond to incoming calls over this interface (these settings
are not necessary for a leased line):
➤
Go to X4E-3BRI, ISDN S0
➧
U
NIT
0
➧
I
NCOMING
C
ALL
A
NSWERING
.
This menu lists the services previously assigned to numbers and offers the
same options as
CM-1BRI, ISDN S0
➧
I
NCOMING
C
ALL
A
NSWERING
for the
The number of ISDN BRI ports available with the expansion card can vary,
depending on how many interfaces are activated by license. You can obtain
any necessary licenses from your dealer.
In most cases, you can accept the preset values for D-Channel, B-Channel 1
and B-Channel 2.
If you use an ISDN leased line and have requested a special service from your
service provider, it may be necessary to set the local side of the leased line at
this point (DTE or DCE). You must then ensure that the far end has set the
opposite value. You must also set D-channel, B-channel 1 and B-channel 2
to the same values, if you have selected several D-/B-channels under ISDN
Switch Type and the values can be changed.