BinTec X4000, User Manual

Page: 128 / 498

128 X4000 User’s Guide
Basic Configuration of Basic Unit with Setup Tool
7
The following parts of the menu are relevant for this configuration step:
Table 7-4: CM-100BT, F
AST
E
THERNET
Field Meaning
Local IP Number IP address of X4000 in the LAN.
Local Netmask Netmask of the network in which X4000 with
Local IP Number is located.
Second Local IP
Number Second IP address of X4000 in the LAN.
Second Local Netmask Netmask of the network in which X4000 with
Second Local IP Number is located.
Encapsulation Defines the kind of header added to the IP
packets that run over this LAN interface.
Possible values:
■
Ethernet II (conforms to IEEE 802.3)
■
Ethernet SNAP
You can generally retain the default value
Ethernet II. The LAN interface is called en1 for
Ethernet II and en1-snap for Ethernet SNAP.
Mode Defines the mode in which the LAN interface is
operated. Possible values:
■
Auto (default value) Automatic detection of
the LAN parameters is activated and the
LAN interface is operated in the appropriate
mode.
■
10 Mbps Half Duplex
■
10 Mbps Full Duplex
■
100 Mbps Half Duplex
■
100 Mbps Full Duplex
You should normally leave the default value at
Auto.