BinTec X4000, User Manual

Page: 43 / 498

X4000 User’s Guide 43
Basic Unit
3
Proceed as follows:
Figure 3-5: Screwing the bracket to the fixing holes
Step 1
➤
Using the two brackets and screws supplied with X4000 , screw the
brackets to the front fixing holes provided on the side of X4000 , see
Figure 3-5, page 43 . Always use the screws supplied. Other screws may
not withstand the mechanical loads or may damage the equipment.
Step 2
➤
Connect the necessary interface cables to the sockets provided (cables
must already be installed if your cabinet is not accessible from the rear!).
Step 3
➤
Slide this preassembled unit with the two brackets screwed to it into the
cabinet and screw the preassembled unit to the longitudinal sections of the
cabinet (these screws are not supplied with
X4000 , but are included with
the cabinet.)