BinTec X4000, User Manual

Page: 193 / 498

X4000 User’s Guide 193
General WAN Settings
8
➤
Enter your Password.
➤
Select CAPI.
➤
Press SAVE.
➤
Repeat these steps for every user in the LAN.
➤
Go to
CM-1BRI, ISDN S0
➧
I
NCOMING
C
ALL
A
NSWERING
.
Make an entry here for every user in the LAN who has access to the CAPI
service.
➤
Select an existing entry and confirm it with Return or add a new entry with
ADD.
➤
Select Item: CAPI.
➤
Enter Number.
➤
Select Mode.
➤
Enter User Name.
➤
Select Bearer.
How to enter the passwords in the Setup Tool is described in "Changing the
password", page 85 .
If you use a communication application on your PC that is based on Remote
CAPI 1.1 (current version: Remote CAPI 2.0),
X4000 must translate the
➤➤
MSN s (= Number, multidigit) of the incoming call to
➤➤
EAZ s (single
digit) (CAPI 1.1 can only detect single-digit numbers). This is why the CAPI
entry under Item is not simply called
"CAPI" but "CAPI 1.1 EAZ x Mapping".
When using CAPI 1.1, you must therefore make sure you assign each CAPI
application the corresponding EAZ(s) by "mapping". For example select for
Number =
1234 the entry Item = CAPI 1.1 EAZ 0 Mapping and for Number =
5678 the entry Item = CAPI 1.1 EAZ 1 Mapping.
CAPI 2.0 evaluates the MSN directly and "translation" to EAZ is not necessary.
You can use the same CAPI 1.1 EAZ x Mapping entry for each Number i.e. a
single entry is sufficient.
You should certainly try to change your PC system to CAPI 2.0 so that you can
also use new features.