BinTec X4000, User Manual

Page: 414 / 498

414 X4000 User’s Guide
Important Commands
14
–
-i
: IP output (B-channel only)
–
-N
: Novell IPX output (B-channel only)
–
-x:
raw dump mode.
–
-X
: asynchronous PPP over X.75 (B-channel only)
–
-T <tei>
: set TEI filter (D-channel only)
–
-c <cref>
: set callref filter (D-channel only)
–
channel
: 0 = D-channel or X.21 interface, 1 ... 31 = Bx-channel
–
unit
: 0 ... 1. selects the physical interface for modules with two
interfaces (e.g. CM-2BRI)
–
slot
: 1 ... 2. indicates the slot in which the module is installed
–
next
: only display information for the next B-channel opened
–
<ifcname>
: name or index of the interface (see "ifstat", page 416 ).
–
-d <destination MAC filter>
: set destination MAC address
filter (LAN only).
–
-s <source MAC filter>
: set source MAC address filter (LAN
only).
–
-o
: combine two or more -d filters or -s filters with a logical OR
operation.
– specific
<MAC filter>
:
me
= X4000 ’s MAC address,
bc
= broadcast
packets.
isdnlogin
isdnlogin [-c <stknumber>] [-C] [-s <service>]
[-a <addinfo>] [-b <bits>] isdn-number [isdn-service]|
layer1-protocol]
Is used to open a remote login shell on X4000 over ISDN.
–
-c <stknumber>
: defines the ISDN stack (if several ISDN cards are
used).
–
-C
: tries to use compression (V.42bis).
You can combine a -d MAC filter and an -s MAC filter with a logical AND
operation by simply specifying them both.
To combine two or more -d and -s MAC filters with a logical OR operation,
specify the filters and separate them with
-o
.