BinTec X4000, User Manual

Page: 188 / 498

188 X4000 User’s Guide
Advanced Configuration of the Basic Unit with the Setup Tool
8
8.1 General WAN Settings
General WAN functions:
■
X4000 as Dynamic IP Address
➤➤
Server ( chapter 8.1.1, page 188 )
■
CAPI User Concept ( chapter 8.1.2, page 190 )
■
General
➤➤
PPP Settings ( chapter 8.1.3, page 194 )
■
Setting of X.31 TEI value ( chapter 8.1.4, page 197 )
These settings are not linked to certain WAN partners, but concern all WAN
connections.
8.1.1 Dynamic IP Address Server
IP address pools X4000 can operate as a dynamic IP address server for PPP connections. You
can use this function by providing one or more pools of
➤➤
IP addresses .
These IP addresses can be assigned to dial-in WAN partners for the duration of
the connection.
Configuration is made in:
■
IP
➧
IP
ADDRESS POOL
WAN (PPP)
■
WAN P
ARTNER
➧
E
DIT
➧
IP
■
WAN P
ARTNER
➧
E
DIT
➧
IP
➧
A
DVANCED
S
ETTINGS
Any host routes entered always have priority over IP addresses from the
address pools. That is, when an incoming call has been authenticated,
X4000
first checks whether a host route is entered in the routing table for this caller. If
not,
X4000 can assign an IP address from an address pool (if available).
If address pools have more than one IP address, you cannot specify which
WAN partner receives which address. The addresses are initially assigned in
order. If a new dial-in takes place within an interval of one hour, an attempt is
made to assign the same IP address assigned to this partner the last time.