BinTec X4000, User Manual

Page: 304 / 498

304 X4000 User’s Guide
Configuration of Expansion and Resource Cards with the Setup Tool
9
➤
Select V.42bis Compression, e.g. auto.
➤
Select MNP5 Compression, e.g.
auto.
➤
Press SAVE.
Modem profile 2 ... 8
configuration
➤
Configure other modem profiles as necessary, see Table 9-11, page 305 .
Incoming Call
Answering
Proceed as follows to assign the defined modem profiles to the dial-in users (the
example values are taken from the scenario in Figure 9-3, page 298 ):
➤
Go to
X4E-3BRI, ISDN S0
➧
U
NIT
0
➧
I
NCOMING
C
ALL
A
NSWERING
if you
wish to assign an incoming dial-in connection over the first interface of an
ISDN BRI expansion card.
➤
Add a new entry with ADD.
➤
Select Item, e.g. PPP Modem Profile 2.
➤
Enter Number, e.g. 091112342.
➤
Select Mode, e.g. right to left.
➤
Select the Bearer, e.g.
any.
➤
Press SAVE.
➤
Add other entries as necessary.
WAN partner Proceed as follows to create WAN partner entries for the dial-in users:
➤
Go to WAN P
ARTNER
, add a new entry with ADD.
You will find detailed information about configuring a WAN partner in
chapter 7.3, page 159 ; the following settings are essential here:
➤
Enter Partner Name, e.g. homeoffice_2.
➤
Select Encapsulation, e.g.
PPP.
➤
Select authentication information in WAN P
ARTNER
➧
ADD
➧
PPP.
➤
Go to WAN P
ARTNER
➧
ADD
➧
A
DVANCED
S
ETTINGS
.
➤
Select Layer 1 Protocol, e.g. Modem Profile 2.
➤
Confirm with OK.
➤
Go to
WAN P
ARTNER
➧
ADD
➧
WAN N
UMBERS
➧
ADD.