Anritsu BERTWave MP2100B, Operation Manual, Page: 142 / 382

Chapter 5 Generating Pulse Signal
5-10
5.3 Procedure for Generating Pulse Signal
The basic procedure is as shown in the following figure.
Starting
The amplitude is set.
Select a standard clock.
Is the bit rate
standard Variable?
The clock is
input to the
connector.
The pattern is set.
The bit rate and the
offset are set.
Data/XData is turned on.
End
Is the external
clock used?
No
Yes
No
Yes
The bit rate
standard is set.
Positive logic/negative-true logic is set.
The amount of external
attenuation is input.
Is an external
attenuator used?
Yes
No
Error Addition
is turned on.
Is the bit error
inserted?
Yes
No
Error Addition
is turned off.
The amount of external
attenuation is adjusted to 0.
Is the insertion
method Repeat?
Yes
No
Rate is
set.
The bit error insertion method is set.
Is the synchronous
output signal used?
Sync Output is
set.
No
Yes
Is the Ext Clk In
connector used?
No
Yes
The clock is input
to the 10 MHz
Input connector.
The ratio of dividing
frequency is set.
Is the pattern
Programmable
Pattern?
The pattern file
is set.
No
Yes
Touch [Apply]
button.
Figure 5.3-1 Basic Procedure of Generating Pulse Signal