Anritsu BERTWave MP2100B, Operation Manual, Page: 11 / 382

For Safety
xi
CAUTION
The equipment is equipped with an internal memory from which, as with
any flash memory, data may be lost under certain conditions. The writing
limitation of flash memory is approximately one million. It is
recommended to periodically back up all important data and programs to
protect them from being lost accidentally.
Anritsu will not be held responsible for lost data.
Note: The flash memory used in this equipment has a maximum writing
time of one million.
To reduce the possibility of data loss, particular attention should be given
to the following points.
●
The equipment should only be used within the recommend
temperature range, and should not be used in locations where the
temperature may fluctuate suddenly.
●
Always follow the guidelines to ensure that the equipment is set up in
the specified manner.
●
Always ensure that the fans at the rear and side of the equipment are
not blocked or obstructed in any way.
●
Exercise care not to bang or shake the equipment whilst the power is
on.
●
Never disconnect the mains power at the plug or cut the power at the
breaker with the equipment turned on.
This equipment is designed for an industrial environment.
In a residential environment, this equipment may cause radio
interference in which case the user may be required to take adequate
measures.
Exposure to corrosive gases such as hydrogen sulfide, sulfurous acid,
and hydrogen chloride will cause faults and failures.
Note that some organic solvents release corrosive gases.
Hard disk
Use in a Residential
Environment
Use in Corrosive
Atmospheres