DI-106
-
DIAGNOSTICS
ENGINE
260
Author:
Date:
2001 SIENNA (RM787U)
2
Connect the OBDII scan tool or TOYOTA hand-held tester and read value for
voltage output of A/F sensors (bank1, 2 sensor1).
PREPARATION:
(a)
Connect the OBD II scan tool or TOYOTA hand-held tester to the DLC3.
(b)
Warm up the A/F sensors (bank1, 2 sensor1) with the engine at 2,500 rpm for approx. 90 sec.
CHECK:
Read voltage of A/F sensors (bank 1, 2 sensor 1) on the screen of OBD II scan tool or TOYOTA hand-held
tester when you perform all the following conditions.
HINT:
The voltage of AFR
and AFL
terminals of ECM is fixed at 3.3 V and the voltage of AFR
and AFL
terminals is fixed at 3.0 V. Therefore, it is impossible to check the A/F sensors (bank1, 2 sensor1) output
voltage at the terminals (AFR
, AFL
/AFR
, AFL
) of ECM.
OK:
Condition
A/F Sensor Voltage value
Engine idling
Engine racing
Not remains at 3.30 V (*0.660 V)
Not remains at 3 8 V (*0 76 V) or more
Driving at engine speed 1,500 rpm or more and vehicle
speed 40 km/h (25 mph) or more, and operate throttle
valve open and close.
Not remains at 3.8 V (*0.76 V) or more
Not remains at 2.8 V (*0.56 V) or less
*: When you use the OBD II scan tool (excluding TOYOTA hand-held tester)
HINT:
During fuel enrichment, there is a case that the output voltage of A/F sensors (bank1, 2 sensor1) is
below 2.8 V (* 0.56 V), it is normal.
During fuel cut, there is a case that the output voltage of A/F sensors (bank1, 2 sensor1) is above 3.8
V (* 0.76 V), it is normal.
If output voltage of A/F sensors (bank1, 2 sensor1) remains at 3.30 V (* 0.660 V) even after performing
all the above conditions, A/F sensors (bank1, 2 sensor1) circuit may be open.
If output voltage of A/F sensors (bank1, 2 sensor1) remains at 3.8 V (* 0.76V) or more, or 2.8 V (*0.56
V) or less even after performing all the above conditions, A/F sensors (bank1, 2 sensor1) circuit may
be short.
*: When you use the OBD II scan tool (excluding TOYOTA hand-held tester).
OK
Go to step 9.
NG
Содержание RM787U
Страница 736: ...DIAGNOSTICS POWER SLIDE DOOR CONTROL SYSTEM DI 505 659 Author Date 2001 SIENNA RM787U f Repeat the step d and e...
Страница 1619: ...BE0EX 03 I03187 Power Outlet BODY ELECTRICAL POWER OUTLET BE 13 1531 Author Date 2001 SIENNA RM787U POWER OUTLET LOCATION...
Страница 1883: ...AC0951 Stator AIR CONDITIONING COMPRESSOR AND MAGNETIC CLUTCH AC 65 1906 Author Date 2001 SIENNA RM787U c Remove the stator...