SA0QS-01
F02203
F02204
F02205
F02206
SST
-
SUSPENSION AND AXLE
FRONT AXLE HUB
SA-9
1296
Author:
Date:
2001 SIENNA (RM787U)
REMOVAL
1.
REMOVE FRONT WHEEL
Torque: 104 N·m (1,050 kgf·cm, 77 ft·lbf)
2.
CHECK BEARING BACKLASH AND AXLE HUB DEVI-
ATION
(a)
Remove the 2 bolts, brake caliper and disc.
(b)
Support the brake caliper securely.
(c)
Set a dial indicator near the center of the axle hub and
check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the bearing.
(d)
Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)
If the deviation exceeds the maximum, replace the bearing.
(e)
Install the disc, 2 bolts and brake caliper.
Torque: 107 N·m (1,090 kgf·cm, 79 ft·lbf)
3.
REMOVE DRIVE SHAFT LOCK NUT
(a)
Remove the cotter pin and lock cap.
(b)
With applying the brakes, remove the nut.
Torque: 294 N·m (3,000 kgf·cm, 217 ft·lbf)
(c)
Remove the brake caliper and disc.
(d)
Support the brake caliper securely.
4.
REMOVE ABS SPEED SENSOR AND WIRE HARNESS
CLAMP
Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
5.
LOOSEN 2 NUTS ON LOWER SIDE OF SHOCK AB-
SORBER
Torque: 210 N·m (2,150 kgf·cm, 155 ft·lbf)
HINT:
Do not remove the bolts.
At the time of installation, coat the nut’s thread with en-
gine oil.
6.
DISCONNECT TIE ROD END FROM STEERING
KNUCKLE
(a)
Remove the cotter pin and nut.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
(b)
Using SST, disconnect the tie rod end from the steering
knuckle.
SST
09610-20012
Содержание RM787U
Страница 736: ...DIAGNOSTICS POWER SLIDE DOOR CONTROL SYSTEM DI 505 659 Author Date 2001 SIENNA RM787U f Repeat the step d and e...
Страница 1619: ...BE0EX 03 I03187 Power Outlet BODY ELECTRICAL POWER OUTLET BE 13 1531 Author Date 2001 SIENNA RM787U POWER OUTLET LOCATION...
Страница 1883: ...AC0951 Stator AIR CONDITIONING COMPRESSOR AND MAGNETIC CLUTCH AC 65 1906 Author Date 2001 SIENNA RM787U c Remove the stator...