Toyota RM787U, Руководство по обслуживанию и ремонту

Страница: 805 / 1976

H01021
AB0118 AB0119
R13006 H01079
H01208
→ ←
E1 Tc
ACC ON
or
Airbag
Sensor
Assembly
P/T Squib (RH)
DTC B0132/61
DLC1
DI-436
- DIAGNOSTICS SUPPLEMENTAL RESTRAINT SYSTEM
590
Author: Date:
2001 SIENNA (RM787U)
4 Check P/T squib (RH).
PREPARATION:
(a)
Turn the ignition switch to LOCK.
(b) Disconnect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the seat belt pretensioner (RH) connector.
(d) Connect negative (-) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
(a)
Turn the ignition switch to ACC or ON, and wait at least
for 20 seconds.
(b) Clear the DTC stored in memory
(See step 5 on page
DI-358 ).
(c) Turn the ignition switch to LOCK, and wait at least for 20
seconds.
(d) Turn the ignition switch to ACC or ON, and wait at least
for 20 seconds.
(e) Check the DTC (See page DI-358 ).
OK:
DTC B0132/61 is not output.
HINT:
Codes other than code B0132/61 may be output at this time, but
they are not relevant to this check.
NG Replace seat belt pretensioner (RH).
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.