BE0FO-03
I04046
Wire Harness Side
s-8-1
N21993
1
2
N21994
2
1
-
BODY ELECTRICAL
SLIDING ROOF SYSTEM
BE-95
1613
Author:
Date:
2001 SIENNA (RM787U)
INSPECTION
1.
INSPECT SLIDING ROOF CONTROL RELAY AND
SWITCH CIRCUIT
Disconnect the connector from the relay and switch and inspect
the connector on the wire harness side, as shown in the chart.
Tester connection
Condition
Specified condition
1 - 5
Constant
Continuity
2 - Ground
Constant
Continuity
3 - Ground
No.1 limit switch OFF (Sliding roof closed)
No continuity
3 - Ground
No.1 limit switch ON (Sliding roof opened)
Continuity
7 - Ground
No.2 limit switch OFF (Sliding roof tilted up or
open approx. 200 mm (7.87 in.)
No continuity
7 - Ground
No.2 limit switch ON (Except for conditions
mentioned above)
Continuity
4 - Ground
Ignition switch LOCK or ACC
*No voltage
4 - Ground
Ignition switch ON
Battery positive voltage
*Exceptions: For 60 seconds after the ignition switch is turned
ON to OFF (ACC) or until driver or passenger door is opened
after the ignition switch is turned ON to OFF (ACC).
If the circuit is as specified, replace the relay and switch.
2.
INSPECT SLIDING ROOF MOTOR OPERATION
(a)
Connect the positive (+) lead from the battery to terminal
1 and the negative (-) lead to terminal 2, check that the
motor turns counterclockwise (for closing and raising op-
erations).
(b)
Reverse the polarity, check that the motor turns clock-
wise. (for opening and lowering operations).
If operation is not as specified, replace the motor.
Содержание RM787U
Страница 736: ...DIAGNOSTICS POWER SLIDE DOOR CONTROL SYSTEM DI 505 659 Author Date 2001 SIENNA RM787U f Repeat the step d and e...
Страница 1619: ...BE0EX 03 I03187 Power Outlet BODY ELECTRICAL POWER OUTLET BE 13 1531 Author Date 2001 SIENNA RM787U POWER OUTLET LOCATION...
Страница 1883: ...AC0951 Stator AIR CONDITIONING COMPRESSOR AND MAGNETIC CLUTCH AC 65 1906 Author Date 2001 SIENNA RM787U c Remove the stator...