Toyota RM787U, Руководство по обслуживанию и ремонту

Страница: 1439 / 1976

SR0DA-02
F02584
R11908
SR-16
- STEERING TILT STEERING COLUMN
1412
Author: Date:
2001 SIENNA (RM787U)
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder.
(c) Install a new cylinder.
HINT:
Make sure the key is at the ACC position.
3.
INSPECT IGNITION SWITCH (See page BE-15 )
4. IF NECESSARY, REPLACE IGNITION SWITCH
(a) Remove the 2 screws and ignition switch from the column
upper bracket.
(b) Install a new ignition switch with the 2 screws.
Torque: 2.2N·m (20kgf·cm, 17in.·lbf)
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page
BE-15 )
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide the key unlock warning switch out of the column up-
per bracket.
(b) Slide a new key unlock warning switch in the column up-
per bracket.
7. INSPECT TRANSPONDER KEY COIL (See page
BE-159 )
8. IF NECESSARY, REPLACE TRANSPONDER KEY
COIL
9. IF NECESSARY, REPLACE TRANSPONDER KEY AM-
PLIFIER
(a) Remove the 2 screws and transponder key amplifier.
(b) Install a new transponder key amplifier with the 2 screws.
10. INSPECT BEARING
(a) Check the bearing rotation condition and check for abnor-
mal noise.
If the bearing is worn or damaged, replace the column tube.