Toyota RM787U, Руководство по обслуживанию и ремонту

Страница: 1689 / 1976

BO3Y3-01
H02652
Adhesive Tape
BO-50
- BODY BODY OUTSIDE MOULDING
1727
Author: Date:
2001 SIENNA (RM787U)
INSTALLATION
1. INSTALL FRONT FENDER OUTSIDE MOULDING
Install the moulding with 2 screws.
2.
INSTALL FRONT DOOR OUTSIDE MOULDING
(a) Clean the door mounting surface.
(1)
Using a heat light, heat the door mounting surface
to 40 - 60
°
C (104 - 140
°
F).
NOTICE:
Do not heat door excessively.
(2) Remove the adhesive tape from the door.
(3) Wipe off stains with cleaner.
(b) If reusing moulding:
Clean the moulding.
(1)
Using a heat light, heat the moulding to 20 - 30
°
C
(68 - 86
°
F).
NOTICE:
Do not heat moulding excessively.
(2) Remove the adhesive tape from the moulding.
(3) Wipe off stains with cleaner.
(4) Apply new adhesive tape to the moulding as shown
in the illustration.
(c) Install the moulding.
(1)
Using a heat light, heat the door and moulding.
Body: 40 - 60
°
C (104 - 140
°
F)
Moulding: 20 - 30
°
C (68 - 86
°
F)
NOTICE:
Do not heat moulding excessively.
(2) Lift the moulding release sheet from the face of
moulding.
NOTICE:
When the moulding release sheet is removed, make sure
that no dirt or dust can get on to the uncoated area.
(3) Install the moulding to the door.
(4) Install the 2 nuts and 2 hole plugs.
3. INSTALL SLIDE DOOR OUTSIDE MOULDING
(a) Clean the door mounting surface.
(1)
Using a heat light, heat the door mounting surface
to 40 - 60
°
C (104 - 140
°
F).
NOTICE:
Do not heat door excessively.
(2) Remove the adhesive tape from the door.
(3) Wipe off stains with cleaner.