Toyota RM787U, Руководство по обслуживанию и ремонту

Страница: 1743 / 1976

H02690
Adhesive
ø = 8.0 mm
63 mm
(2.48 in.)
25 mm
(0.98 in.)
57 mm
(2.24 in.)
(0.31 in.)
Adhesive
ø = 8.0 mm
(0.31 in.)
25 mm
(0.98 in.)
H02691
400 mm
(15.75 In.)
a
400 mm
(15.75 in.)
a
Apply Soapy Water Area
a - a
Apply Soapy Water Area
H02692
BO-56
- BODY ROOF DRIP SIDE FINISH MOULDING
1733
Author: Date:
2001 SIENNA (RM787U)
4. APPLY ADHESIVE
(a) Cut off the tip of the cartridge nozzle.
(b) Load the cartridge into the sealer gun.
(c) Coat the moulding with adhesive as shown in the illustra-
tion.
5. INSTALL ROOF DRIP SIDE FINISH MOULDING
(a) Apply soapy water to contact surface of the moulding as
shown in the illustration.
(b) Using a heat light, heat the body and moulding.
Body: 40 - 60
°
C (104 - 140
°
F)
Moulding: 20 - 30
°
C (68 - 86
°
F)
NOTICE:
Do not heat moulding excessively.
(c)
Remove the moulding release sheet from the face of
moulding.
NOTICE:
When the moulding release sheet is removed, make sure
that no dirt or dust can get onto the uncoated area.
(d) Push the moulding to the body, as shown in the illustra-
tion.
NOTICE:
Do not depress the adhesive coated parts excessive-
ly but just hold them down with your thumb.
Scrape off any overflowing adhesive with a plastic
spatula and clean the surface with a dry rag.
After installation, do not wash the vehicle for 24
hours.