FI2553
SST
S05054
New Gasket
SF-2
-
SFI
SFI SYSTEM
1077
Author:
Date:
2001 SIENNA (RM787U)
(b)
When installing the battery, be especially careful not to in-
correctly connect the positive (+) and negative (-) cables.
(c)
Do not permit parts to receive a severe impact during re-
moval or installation. Handle all SFI parts carefully, espe-
cially the ECM.
(d)
Be careful during troubleshooting as there are numerous
transistor circuit, and even slight terminal contact can
cause further troubles.
(e)
Do not open the ECM cover.
(f)
When inspecting during rainy weather, take care to pre-
vent entry of water. Also, when washing the engine
compartment, prevent water from getting on the SFI parts
and wiring connectors.
(g)
Parts should be replaced as an assembly.
(h)
Care should be taken when pulling out and inserting wir-
ing connectors.
(1)
Release the lock and pull out the connector, pulling
on the connectors.
(2)
Fully insert the connector and check that it is locked.
(i)
Use SST for inspection or test of the injector or its wiring
connector.
SST
09842-30070
8.
FUEL SYSTEM
(a)
When disconnecting the high fuel pressure line, a large
amount of gasoline will spill out, so observe these proce-
dures:
(1)
Put a container under the connection.
(2)
Disconnect the fuel pipe (See step (f)).
(3)
Plug the connection with a rubber plug.
(b)
When connecting the union bolt on the high pressure pipe
union, observe these procedures:
(1)
Always use 2 new gaskets.
(2)
Tighten the union bolt by hand.
(3)
Tighten the union bolt to the specified torque.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
Содержание RM787U
Страница 736: ...DIAGNOSTICS POWER SLIDE DOOR CONTROL SYSTEM DI 505 659 Author Date 2001 SIENNA RM787U f Repeat the step d and e...
Страница 1619: ...BE0EX 03 I03187 Power Outlet BODY ELECTRICAL POWER OUTLET BE 13 1531 Author Date 2001 SIENNA RM787U POWER OUTLET LOCATION...
Страница 1883: ...AC0951 Stator AIR CONDITIONING COMPRESSOR AND MAGNETIC CLUTCH AC 65 1906 Author Date 2001 SIENNA RM787U c Remove the stator...