Toyota RM787U, Руководство по обслуживанию и ремонту

Страница: 999 / 1976

A05194
L = 133 mm (5.24 in.)
L = 180 mm (7.09 in.)
L = 72 mm (2.83 in.)
L = 335 mm (13.19 in.)
L = 180 mm
(7.09 in.)
L = Length
Join
Line
Join
Line
Z14262
New Gasket
EM-68
- ENGINE MECHANICAL CYLINDER HEAD
1011
Author: Date:
2001 SIENNA (RM787U)
19. INSTALL NO.3 TIMING BELT COVER
(a) Check that the timing belt cover gaskets have no cracks
or peeling, etc.
If the gaskets have cracks or peeling etc., replace them using
these steps:
Using a screwdriver and gasket scraper, remove all
the old gasket material.
Thoroughly clean all components to remove all the
loose material.
Remove the backing paper from a new gasket and
install the gasket evenly to the part of the timing belt
cover shaded black in the illustration.
NOTICE:
When joining 2 gaskets, do not leave a gap between them.
Cut off any excess gasket.
After installing the gasket, press down on it so that
the adhesive firmly sticks to the timing belt cover.
(b) Install the timing belt cover with the 6 bolts.
Torque: 8.5 N·m (85 kgf·cm, 74 in.·lbf)
(c) Install the 3 engine wire clamps to the timing belt cover.
20. INSTALL NO.2 IDLER PULLEY (See page EM-22 )
21. INSTALL CAMSHAFT TIMING PULLEYS (See page
EM-22 )
22. INSTALL TIMING BELT (See page EM-22 )
23. INSTALL SPARK PLUGS
24. INSTALL IGNITION COILS
25. INSTALL WATER OUTLET
(a) Install 2 new gaskets.
(b) Connect the water outlet to the bypass hose.
(c) Install the water outlet with the 2 bolts, 2 nuts and 2 plate
washers. Alternately tighten the bolts and nuts.
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
NOTICE:
Do not scratch the seal surface of the water outlet with the
stud bolt.
(d)
Connect the ECT sender gauge connector.
(e) Connect the ECT sensor connector.
(f) Connect the ground strap connector.
(g) Connect the upper radiator hose.
(h) Connect the engine coolant reservoir hose.