Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 301 / 500

13. USING A LINEAR SERVO MOTOR
13 - 52
(2) List of details
No. Symbol Name Setting
Factory
setting
Unit
Setting
range
PD02 *DIA2 Input signal automatic ON selection
Select the input devices to be automatically turned ON.
0
BIN 0: Used as external input signal
BIN 1: Automatic ON
Factory setting
BIN HEX
Signal name
0
0
0
Upper stroke limit
(FLS)
0
0
0 0
Lower stroke limit
(RLS)
For example, to turn ON RLS, the setting is " 2".
When the upper stroke limit (FLS) or the lower stroke limit (RLS) is used on the
controller side, do not set to automatically ON since the magnetic pole detection
signal is shared with the input signal.
Each
axis
0000h Refer to
name
and
function
column.
13.6.6 Special setting parameters (No.PS
)
(1) Parameter list
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
No. Symbol Name
Setting
(Note 1)
Factory
setting
(Note 2)
Unit
Reference
PS01 **LIT1 Linear function selection 1 Each
axis
0301h
PS02 **LIM Linear encoder resolution setting Numerator Each
axis
1000
PS03 **LID Linear encoder resolution setting Denominator Each
axis
1000
This
section
(2)
PS04 *LIT2 Linear function selection 2 Each
axis
0003h
PS05 LB1 Linear servo motor control position deviation error detection level Each
axis
0 mm
PS06 LB2 Linear servo motor control speed deviation error detection level Each
axis
0 mm/s
PS07 LB3 Linear servo motor control thrust deviation error detection level Each
axis
100